Quotes4study

The vital appliance is a rapidly revolving mirror. Let AB (fig. 3) be a section of this mirror, which we shall first suppose at rest. A ray of light LM emanating from a source at L, is reflected in the direction MQR to a distant mirror R, from which it is perpendicularly reflected back upon its original course. This mirror R should be slightly concave, with the centre of curvature near M, so that the ray shall always be reflected back to M on whatever point of R it may fall. Conceiving the revolving mirror M as at rest, the return ray will after three reflections, at M, R and M again, be returned along its original course to the point L from which it emanated. An important point is that the return ray will always follow the fixed line ML no matter what the position of the movable mirror M, provided there is a distant reflector to send the ray back. Now, suppose that, while the ray is going and coming, the mirror M, being set in revolution, has turned from the position in which the ray was reflected to that shown by the dotted line. If [alpha] be the angle through which the surface has turned, the course of the return ray, after reflection, will then deviate from ML by the angle 2[alpha], and so be thrown to a point E, such that the angle LME = 2[alpha]. If the mirror is in rapid rotation the ray reflected from it will strike the distant mirror as a series of flashes, each formed by the light reflected when the mirror was in the position AB. If the speed of rotation is uniform, the reflected rays from the successive flashes while the mirror is in the dotted position will thus all follow the same direction ME after their second reflection from the mirror. If the motion is sufficiently rapid an eye observing the reflected ray will see the flashes as an invariable point of light so long as the speed of revolution remains constant. The time required for the light to go and come is then equal to that required by the mirror to turn through half the angle LME, which is therefore to be measured. In practice it is necessary on this system, as well as on that of Fizeau, to condense the light by means of a lens, Q, so placed that L and R shall be at conjugate foci. The position of the lens may be either between the luminous point L and the mirror M, or between M and R, the latter being the only one shown in the figure. This position has the advantage that more light can be concentrated, but it has the disadvantage that, with a given magnifying power, the effect of atmospheric undulation, when the concave reflector is situated at a great distance, is increased in the ratio of the focal length of the lens to the distance LM from the light to the mirror. To state the fact in another form, the amplitude of the disturbances produced by the air in linear measure are proportional to the focal distance of the lens, while the magnification required increases in the inverse ratio of the distance LM. Another difficulty associated with the Foucault system in the form in which its originator used it is that if the axis of the mirror is at right angles to the course of the ray, the light from the source L will be flashed directly into the eye of the observer, on every passage of the revolving mirror through the position in which its normal bisects the two courses of the ray. This may be avoided by inclining the axis of the mirror. Entry: III

Encyclopaedia Britannica, 11th Edition, Volume 16, Slice 5 "Letter" to "Lightfoot, John"     1910-1911

Index: